led燈珠降電流 |
| 發布時間:2022-10-09 12:03:10 |
大家好我是小編沁夢今天我們來介紹led燈珠降電流 led燈珠反向電壓的問題，以下就是沁夢對此問題和相關問題的歸納整理,一起來看看吧。 文章目錄導航: led燈珠為什么加電阻 加電阻是為了降電流，電流過大燈珠芯片很容易燒壞。根據每個型號燈珠芯片的不同需要使用的電阻也是不一樣的。希望能幫到您
led燈珠點亮后反向電流減小 燈珠點亮后，隨著溫度的升高燈珠的額定工作電壓是會降低的，平均每升高10℃額定電壓下降0.03-0.05V，所以大功率燈珠需要用恒流電源驅動，在溫度升高額定電壓降低的時候保持電流不變從而達到抑制溫升的目的。 如果是說從打開到熄滅這一段時間的話，溫度的升高會導致電流的上升，從而導致電壓降的下降。至于長時間（半年）的我就不清楚了。 隨溫度升高而降低 led燈珠電流過大解決辦法 LED燈珠電流過大的解決辦法，可以加限流電阻或降低電壓來解決。 led燈太亮了怎樣減小電流和功率 led燈與配套驅動器是按功率計算好的，保證led燈工作電流在合理范圍內，如果燈太亮可換功率小點的燈。對現有的燈減小亮度只有把驅動器輸出電流減小。可在驅動器輸出端串接合適電阻加以限流，缺點是電阻也耗電。 對驅動器和燈板一體的燈，把驅動器輸出端線路板上的銅泊斷開，串入合適電阻。 燈珠加電阻怎么調節 用的是白光LED吧因為LED品種很多，功率不一樣，額(e)定的電流也不一樣，找到LED的額(e)定電流，才能確定使用多大的電阻。 一般LED白光，工作電壓在3.2到3.4,電流要看LED額(e)定電流，比如一個1W的燈珠，額(e)定電流一般是350MA，一般我會降低電流來提高壽命，會取工作電流300mA內，工作電壓取3.2，usb 5V，這樣電阻分壓就是5減去3.2，電流300，歐姆定律就可以算出電阻大小（有條件接通后，用測電流，微調，這個也是取電流低于額(e)定電流的用處），不過需要注意的是這個電阻功率是要比較大的，耗在電阻上的有0.5W左右，取2倍以上，要用1W以上的電阻。如果多顆燈珠，就要并聯了，當然了因為USB2.0的電流只有500mA左右，并聯多了，只會電流更低而已，串聯的電阻功率要更大了，還有一個就是要注意的是LED的散熱問題，如果鋁基板小，散熱條件差點的，盡量降低電流。目前我用3顆1W并聯，串了7歐多點的電阻（三顆1W，22歐電阻并聯），已經用了2年多了，主要是晚上，關燈了照屏幕，不然太刺眼了 以上就是天成小編對于led燈珠降電流 led燈珠反向電壓問題和相關問題的解答了，希望對你有用 【責任編輯：沁夢】 |
